Datasheet: TSI-8455-09 |
 |
| TSI 8455-09 Air Velocity Transducer Description: |
 TSI 8455-09 Air Velocity Transducer is ideal for both temporary and permanent installations for air velocity measurements in research and development labs, manufacturing processes, and other applications.

This air velocity transducer contains on-board electronics and calibration curves that provide a linear signal output, which sent out as either a current (mA) or a voltage (V) signal, allowing output to a variety of data loggers or data acquisition systems.
Product made in USA and comes with NIST Certificate of Calibration.
 |
| TSI 8455-09 Air Velocity Transducer Applications: |
| |
 Comfort and draft studies
 |
| |
 Critical environment installations (e.g., clean rooms and hospitals)
 |
| |
 Diffuser design analysis
 |
| |
 Monitoring drying processes
 |
| |
 Monitoring air flows in tunnels and subways
 |
| |
 Used as a standard in wind tunnels and calibration facilities
 |
| |
 Environmental monitoring in greenhouses and IAQ applications
 |
| |
 General engineering applications
 |
| TSI 8455-09 Air Velocity Transducer Characteristics: |
| |
 Protected probe tip
 |
| |
 9 inch probe
 |
| |
 Rugged ceramic sensor
 |
| |
 Wide range of measurement applications
 |
| |
 Fast response time
 |
| |
 Range: 25 to 10,000 ft/min (0.125 to 50 m/s)
 |
| Includes: |
 Probe attached to 16.4-ft (5-m) cable connected to control module, Compression fittings for mounting in duct work, Two holding clips to mount probe to parallel surface, Operation and service manual, NIST calibration certificate
 |
| Warranty |
 Two-year limited warranty
 |

Need Technical Advise? Please Call: 602-795-4033
Browse Similar Products |