Amprobe INSP-3 Inspector Wiring Tester and Verifier

by Amprobe

Model Number: INSP-3

Description: Amprobe INS-P3 Wiring Inspector Tester is a rugged tester designed to verify building wiring compliance to electrical code, especially voltage drop under load. Special price!

Write your own review of this product.

Was $399.95

Now $305.85

Availability: In stock

You Save: $94.10( 23.53% )

Product Description

Amprobe INSP-3 Inspector Wiring Tester and Verifier is a durable tester used to verify building wiring compliance to electrical code, especially voltage drop under load. Amprobe INSP-3 Wiring Inspector Tester identifies issues with splices, connections and conductor quality and is crucial to electrical system safety and performance. Special price!

Characteristics

Chracteristics:Amprobe INSP-3 Inspector Wiring Tester and Verifier
 All relevant test data for testing efficiency (voltage, voltage drop, hot and neutral voltage drop, voltage with load, ground impedance) shown on one display to save user time - no scrolling or switching screens required
 If wiring is tested for load carrying ability, it verifies that electrical code recommendations are met for voltage drop under load
 Faulty wiring in need of repair is detected without removing outlet covers or plates or panel covers. Meter also detects faulty splices and connections, incorrect or undersized wiring, faulty GFCIs, faulty or incorrectly wired AFCIs, Incorrect line voltage and poor ground quality
 0, 10, 15, and 20 amps loads are user selectable to verify performance of the electrical system
 Flashing screen clearly indicates incorrect wiring or voltage drop test failure
 Testing will not trip circuit breakers or blow fuses
 GFCI and AFCI operations are tested
 Verifies ground quality for safety and ability to support sensitive electronic equipment
 Fault currents are measured
 Guesswork is eliminated thereby saving money and time
 Instruction manual included

Specifications

Specifications: Amprobe INSP-3 Wiring Inspector Tester
Load Constant 0, 10, 15 or 20 AMP simulation regardless of line voltage
Operating Voltage 95-140 VAC plus/minus 2 percent, plus/minus 2 digits
GFI Trip 6.0 mA nominal to trip GFI, 30 mA to trip RCD
AFCI Trip Up to 8, 120 AMP pulses within 1/2 second period

Documents

Technical Specs for Amprobe INSP-3 Inspector Wiring Tester and Verifier:

View FileAmprobe INSP-3 Inspector Wiring Tester and Verifier    Size: (234.97 KB)

You May Also Like...