Main page content
Fluke 789 ProcessMeter Digital Multimeter and Loop Calibrator
1633984
QVT-2008080514463716710
Electrical
Fluke 789 Process Meter tester has a 24-Volt loop stream that reduces the need to take an extra battery when doing offline transmitter testing. This meter also has an incorporated 250-Ohm Hart resistor with selectable settings, which removes the need to carry an extra resistor.
Features
| Chracteristics: | Fluke 789 ProcessMeter Digital Multimeter and Loop Calibrator |
| Oversized dual-screens w/backlight that has 2 settings | |
| Ohm drive ability on mA source HART mode setting with loop power and an internal 250 ohm resistor that has 0% and 100 % buttons to toggle between 4 and 20 mA sourcing for a quick span check | |
| Outwardly reachable fuses and battery for easy replacement | |
| Infrared-port to process data in Fluke View Forms (V2.1) software Precision 1000 Volt, 440 mA | |
| TRMS readings | |
| Min/Max/Average/Touch Hold/Relative modes/Diode test and stability beeper | |
| Concurrent mA and % of scale readout | |
| 20 mA Direct Current source / loop calibrator / simulator | |
| Manual Step (100%, 25%, Coarse, Fine), Auto Step, and Auto Ramp | |
| Meets 1000 Volt EN61010-1 CAT III safety standards and 600 Volt EN61010-1 CAT IV safety standards. | |
| 3yr. warranty | |
| Virtual Product & clamp meter demo |
Specifications
Proposition 65 Warning for California Residents: This product can expose you to chemicals including Benzene, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Resources
